[. . . ] The countertop must be bonded with heat resistant (212 °F/100 °C) adhesive to prevent distortion. The cooktops should only be installed in the illustrations, while maintaining the required safety distances shown. [. . . ] Number of cooktops 1 2 3 4 5 All Miele combisets have the same length and width. Make sure that there is enough room beneath the countertop to allow for the depth of the various appliances. When installing a KM 402 / KM 403 or KM 410 / KM 411 remember to allow clearance for the drain valve that will be located in the cabinet beneath the appliances. 6 7 Cut out width Dimension "B" 10 13/16" 22 1/8" 33 7/16" 44 13/16 56 1/8" 67 1/2" 78 13/16" (274 mm) (562 mm) (850 mm) (1138 mm) (1426 mm) (1714 mm) (2002 mm) The tolerance for each dimension is 1 /16" (1 mm). The following safety distances must be maintained: ­ Between the cooktop and rear wall: 2" (50 mm). ­ Between the cooktop and side wall or cabinet: KM 400 = 2" (50 mm) KM 402 / 403= 2" (50 mm) KM 408-1 = 2" (50 mm) KM 410 / 411 =10" (250 mm) Refer to section "Important Safety Instructions" for further information. When installing more than one combiset cooktop, a support bar must be installed between the appliances. Install the support bars as shown on the following page before setting the appliances into the countertop. 9 Installation Laying out the support bars and clamps a Clamps b Support bars This illustration shows the layout for 3 combisets, their respective support bars, b, and the 14 spring clamps, a, required for correct installation. If more than 3 combisets are being installed, add an additional 11 3/8" (288 mm) to the overall width of the cut out for each extra combiset, or use the table on the preceding page. c Slight gap between support bar and countertop. 10 Installation Securing the support bars Securing the spring clamps d c Wood or Corian countertops ^ Arrange the bars, b, as shown in the illustration ^ Drill 1/16" (1. 5 mm) pilot holes through the brackets and secure them using the supplied screws. ^ Fill the gap, c, between the bars and the countertop using the supplied silicon sealant. Wood or Corian countertops ^ Place the spring clamps, a, as shown in the illustration. ^ Drill two 1/16" (1. 5 mm) pilot holes for each clamp and secure using the supplied screws. Granite countertops For granite countertops, the support bars, b, can be secured using double-sided construction tape. Do not allow the bars to "float", they must be securely fastened. Fill the gap, c, between the bars and the countertop using the supplied silicon sealant. [. . . ] The manufacturer cannot be held responsible for damages caused by the lack, or inadequacy of an, effective grounding system. Power supply: ­ 240 V, 60 Hz, 15 A fuse rating or ­ 208 V, 60 Hz, 15 A fuse rating The oven is equipped with a power cord consisting of 3 leads. [. . . ]